Troubleshooting; Application Examples And Faqs - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

Technical Support
A.2 Troubleshooting
A.2

Troubleshooting

This section contains information on localizing and rectifying possible faults.
Error message
"Reset system memory card
failed"
"Start automatic backup failed"
"System card error"
A.3

Application examples and FAQs

Application examples
You can find application examples on the Internet at the following address:
Application Examples Unified Comfort Panels
(https://support.industry.siemens.com/cs/ww/en/ps/26032/ae).
FAQs
Frequently asked questions on Unified Comfort Panels are available on the Internet at the
following address: FAQs Unified Comfort Panels
(https://support.industry.siemens.com/cs/ww/en/ps/26032/faq)
168
Possible cause Remedy
System memory card Replace the defective system memory
is defective or wrong card with a new SIMATIC SD memory
system memory card card ≥ 32 GB.
is inserted.
The system memory Replace the system memory card with
card from a device of a the system memory card of a device of
different type has been the same type.
inserted.
You can use the system memory card
with the device without using the data of
the system memory card. In this case, all
the data in the
"\System Card\SIMATIC.HMI\Active"
folder will be deleted.
Operating Instructions, 03/2020, A5E46641217-AA
Unified Comfort Panels