Mounting And Connecting The Device; Preparing For Installation; Checking The Delivery; Checking The Operating Conditions - Siemens SIMATIC HMI Unified Comfort MTP700 Operating Instructions Manual

Mounting and connecting the device

3.1

Preparing for installation

3.1.1

Checking the delivery

Check the package content for visible signs of transport damage and for completeness.
Note
Damaged parts
A damaged part will cause the HMI device to malfunction.
Do not install parts damaged during shipment. In the case of damaged parts, contact your
Siemens representative.
Check the scope of delivery of the HMI device, see section "Scope of delivery (Page 13)".
Additional documents may be included in the scope of delivery.
The documentation is part of the HMI device and is required for subsequent commissioning.
Keep all enclosed documentation for the entire service life of the HMI device. You must pass
along the enclosed documentation to any subsequent owner or user of the HMI device.
Make sure that every supplement to the documentation that you receive is stored together
with the operating instructions.
3.1.2

Checking the operating conditions

Observe the following aspects before installing the HMI device:
1. Familiarize yourself with the standards, approvals, EMC parameters and technical
specifications for operation of the HMI device. This information is available in the
following sections:
– "Labels, certificates and approvals (Page 139)"
– "Electromagnetic compatibility (Page 144)"
2. Check the mechanical and climatic ambient conditions for operation of the HMI device
according to the following sections:
– " Mechanical ambient conditions (Page 146)"
– " Climatic ambient conditions (Page 147)"
3. Observe the notes on the local use of the HMI device in section "Notes about usage
(Page 24)".
4. Observe the permissible rated current: +24 V DC
Unified Comfort Panels
Operating Instructions, 03/2020, A5E46641217-AA
3
29