11. Adjusting the Media Sensors
The two types of media sensors are equipped in this printer as below.
Feed gap sensor (transmissive): Detects the length between the labels.
Black mark sensor (reflective): Detects the black marks printed on the back side of the media.
When the media is changed to another one, it is necessary to adjust the sensitivity of these two sensors.
Otherwise, printed black marks are not detected and an error will occur as a result.
Feed gap sensor
The position [1] of the feed gap sensor is fixed. Align the protrusion of the black mark sensor [2] to the position as
shown in the figure below.
Be sure to perform calibration of the media sensors whenever you change the media type.
For details, refer to "BV400 Series Key Operation Specification" in the CD-ROM.
The feed gap sensor is positioned 6.27 mm right from the media center.
Black mark sensor
Slide the black mark sensor [2] toward the right or left to align it to the center of the black mark
1
of the media.
The black mark sensor is movable over the range of the media width [3].
Adjust the sensitivity of the black mark sensor.
2
For details, refer to "BV400 Series Key Operation Specification" in the CD-ROM.
30 11. Adjusting the Media Sensors
[ 1 ]
6.27mm
[ 2 ]
[ 2 ]
[ 3 ]
[ 2 ]