Toshiba BV410D-GS02-QM-S Owner's Manual page 41

LCD message
EXCESS HEAD TEMP
MEMORY WRITE
ERR.
FORMAT ERROR
MEMORY FULL
SYNTAX ERROR
SYSTEM ERROR
 BV420D
LED
POWER ONLINE
ON ON
ON Blink
ON OFF
ON OFF
40 14. Troubleshooting
LED
ONLINE ERROR
OFF ON The print head is too hot.
OFF ON An error has occurred during writing into the flash ROM.
OFF ON An error has occurred during initialization of the flash ROM.
OFF ON Saving has failed due to the flash ROM having insufficient blank space.
OFF ON An improper command such as a print command has been received
while the firmware is being upgraded in the download mode.
OFF ON When any abnormal operations as below are performed, a system
error occurs.
(a) Command fetch from an odd address.
(b) Access to the word data from a place other than the boundary of
the word data.
(c) Access to the long word data from a place other than the boundary
of the long word data.
(d) Access to the area of 80000000H to FFFFFFFFH in the logic space in
the user system mode.
(e) Undefined command placed in other than the delay slot has been
decoded.
(f) Undefined command in the delay slot has been decoded.
(g) Command to rewrite the delay slot has been decoded.
ERROR
OFF Normal - Online mode
OFF Normal - Online mode (communicating)
OFF 1. The top cover is opened in the online mode.
2. Printing is temporarily stopped (paused).
ON 1. A communication error has occurred. (Only when the RS-232C is used)
2-1. Media jamming has occurred.
2-2. The media is not loaded correctly.
2-3. The media sensors differing from the media to be used are selected.
2-4. The black mark sensor is not correctly aligned to the black marks on
the media.
2-5. The size of the loaded media differs from that for the specified paper
size.
2-6. The media sensor level is not suitable for the actual media.
2-7. The gap of the pre-printed label cannot be detected.
3. Media jamming has occurred in the cutter unit.
4. No media is left.
5. Printing or media feeding is attempted while the top cover is opened.
6. There is a problem in the print head.
7. The temperature of the print head has exceeded the upper limit.
8. An error has occurred during writing into the flash ROM.
9. An error has occurred during initialization of the flash ROM.
10. Saving has failed due to the flash ROM having insufficient blank space.
Printer status
Printer status