Cut the edge of the media with scissors.
[1] Feed gap sensor
[2] Platen roller
[3] Black mark sensor
Load the media.
5
Pass the media through the media guides [1] and pull it until it reaches the front of the printer.
Do not squeeze the media too much with the media guides. Otherwise, the media will bend and this may cause
jamming or misfeeding.
Adjust the media sensors.
6
For details, refer to P.30 "11. Adjusting the Media Sensors".
Close the top cover.
7
For details, refer to P.25 "9. Opening and Closing the Top Cover".
Be sure to close the top cover completely. Otherwise, this may affect the print quality.
Press the [FEED] button.
8
Check that the media is fed correctly.
28 10. Loading the Media
[ 1 ]
[ 2 ]
[ 3 ]
[ 1 ]
[ 2 ]
[ 3 ]
[ 1 ]
[ 1 ]