Printing can be performed with both an outside wound [1] and an inside wound [2] media roll. (Refer to the
figure below.) Place the media roll so that its printing surface comes upward.
Place the media roll.
3
Set the media roll [1] between the media roll holders [2] while its printing surface comes upward.
When placing the media roll, be careful not to let it be folded by coming into contact with the media damper
(upper) [3] and the media damper (lower) [4] attached to the top cover and the printer.
Align the media guides [1] to the media roll width.
4
While holding the holder lock lever [2], slide the media holder [3] to fix the media roll securely.
Check that the printer printing surface has come upward.
[ 1 ]
[ 1 ]
[ 2 ]
[ 4 ]
[ 1 ]
[ 2 ]
[ 3 ]
[ 2 ]
[ 3 ]
[ 2 ]
10. Loading the Media 27