Loading the fanfold paper
Set the fanfold paper while its printing surface comes upward.
Place the stack of fanfold paper parallel to the paper slot.
Check that the interface cable and the power cable do not interfere with the feeding of the fanfold paper.
Place the stack of fanfold paper [1] at the rear side of the printer and insert its leading edge into
1
the paper slot [2].
Open the top cover.
2
For details, refer to P.25 "9. Opening and Closing the Top Cover".
Pass the media through the media guides [1] and pull it until it reaches the front of the printer.
3
Do not squeeze the media too much with the media guides. Otherwise, the media will bend and this may cause
jamming or misfeeding.
Close the top cover.
4
For details, refer to P.25 "9. Opening and Closing the Top Cover".
[ 1 ]
[ 2 ]
[ 1 ]
[ 1 ]
10. Loading the Media 29