Deleting An Array - Adaptec RAID 2100S Software User's Manual

3
Select RAID 0 for the RAID type and click Ok.
4
Select two or more arrays of the same type from the list of
eligible devices, then click Done.
Note: You cannot combine arrays that use different RAID
levels.
5
Select File > Set System Config to begin the build process for
the multilevel RAID.
The Tree View displays the multilevel RAID LSU as
(x,x,x,x) FW RAID-0
with the array groups listed where drives would normally be listed.
Selecting an array group component branches to the hard drives for
that array group. The LSU address is the lowest address of the array
logical addresses that comprise the multilevel RAID.

Deleting an Array

To delete an array, follow these steps:
1
In the left pane, highlight the array that you want to remove.
Then, select RAID > Delete.
2
A warning message appears, as shown in Figure 2-18. Select
Yes or No. The array configuration for the devices is not
deleted until you select File > Set System Config or exit
SMOR and choose to save your changes.
Delete array
Are you sure you want to delete this
array? All data will be lost.
No
Figure 2-18. Delete Array Window
Storage Manager on ROM
Yes
2-29