Command Line Switches
Following is a list of the switches available in RAIDUTIL for testing
and controlling various aspects of the controller, arrays, and drives
attached to the controller.
Type
Miscellaneous
Logical Drive
Creation/Deletion
Array Modification
RAID Operation
Controller-specific
Hot Spare Control
General
Information
Display Parameters
Switch
Description
-g
Specify drive group
-c
Specify controller ID (OS)
-d
Specify controller ID (BIOS)
-D
Delete logical drives
-l
Specify new logical drive RAID level
-s
Specify logical drive capacity
-z
Specify logical drive stripe size
-E
Expand disk array
-f
Force array state
-C
Load/save configuration
-r
Specify task rate
-w
Write caching
-a
Action (task) control
-F
Update controller firmware, BIOS, or
NVRAM
Reset NVRAM configuration
-X
Reset/clear embedded RAID
-Z
information
-h
Create hot spare drive
-H
Delete hot spare drive
-?
Display utility usage information
-A
Alarm status and control
-e
Display or delete event log messages
-I
Display inquiry information
-L
List devices
-P
Paginate output
-q
Quiet mode
RAIDUTIL Command Line Utility
4-3