Select Default to reset the parameters on this tab to their default
values (SCSI only).
Controller Parameter
ID
Type
Width
Transfer Rate
Termination
TERMPWR
Note: As reported means that the field displays the value
returned by the controller firmware.
Bus
Each peripheral bus on a controller is assigned a number.
Numbering starts with 0 for the first bus, 1 for the second bus, and
so on.
ID (SCSI only)
SCSI RAID controllers are configured by default at ID 7. This value
should not be changed unless required for special configurations.
Type
This is the type of bus (Ultra, Ultra2, Ultra3, ATA/100, etc.).
Width (SCSI only)
The width of the parallel bus (8-bit or 16-bit).
Default
7
As reported
As reported
Maximum allowed
for the controller
Auto
On
Storage Manager on ROM
Available Settings
SCSI: 0 – 6
ATA: not shown
N/A
N/A
Ultra3, Ultra2, Ultra,
10, 8, 5 Asynchronous
On, Off, High Only
Auto, Off
2-18