Running Smor - Adaptec RAID 2100S Software User's Manual

Running SMOR

Start SMOR by pressing Ctrl+A when the RAID controller BIOS
message appears on the screen during the boot sequence. SMOR
starts by displaying its opening screen, as shown in
(showing the opening screen from a 2400A).
The letters that appear during the initial device scan process are
C
D
E
H
T
0, 1, 5
The position of a letter corresponds to the device ID assigned to that
device.
Figure 2-2. SMOR Welcome Window
CD
Hard drive
SAF-TE, intelligent RAID enclosure, or processor
device
Hot spare drives
Tape device
Physical arrays identified by the RAID level
Storage Manager on ROM
Figure 2-2
2-9