Table of Contents
Advertisement
Maintaining the DuraStor 312R Storage
Enclosure
This section provides detailed instructions for
Replacing a disk drive. (See
I
Replacing a cooling fan module. (See
I
Replacing a power supply unit. (See
I
Replacing the disk I/O card. (See
I
Replacing the SAF-TE controller card. (See
I
Replacing the DuraStor 312R chassis. (See
I
Replacing a Disk Drive
When a disk drive fails
Its Drive Status LED flashes (amber if the disk drive is assigned
I
to an array, green if the disk drive is unassigned).
Its Drive Activity LED lights up solid amber.
I
The alarm sounds.
I
The system monitor displays an error event.
I
A failed disk drive should be replaced immediately.
Warning: Drives and printed circuit board components are
sensitive to electrostatic discharge. To prevent damage,
establish a ground for yourself by using a wrist grounding
strap, or by touching the metal chassis prior to handling
the disk drives or printed circuit board components.
Note: The disk drives are hot-swappable. There is no need
to power off the DuraStor 312R or the host computer
system. However, when removing a disk drive, ensure that
it doesn't twist in your hand as a result of the spinning
disk. Pull it slightly from its locked position and allow it to
spin down completely before removing it.
Maintaining the DuraStor Storage Subsystem
page
5-7.)
page
page
5-10.)
page
5-12.)
page
5-9.)
page
5-13.)
5-14.)
5-7
Advertisement
Table of Contents
