Adaptec Disk Array Administrator; The Operator Control Panel - Adaptec DuraStor 6200SR Installation And User Manual

Introduction

Adaptec Disk Array Administrator

® ®
If you are not using Windows NT or Windows 2000 as your OS,
you will need to use Disk Array Administrator to manage your
storage system.
Disk Array Administrator is firmware built into the DuraStor
6200S RAID controller BIOS, and can be accessed using the RS-232
serial port connection on the rear panel of the DuraStor 6200SR
RAID appliance. See Accessing Disk Array Administrator on
page 3-25 for detailed instructions.
You can find the Adaptec Disk Array Administrator User's Guide on
the DuraStor CD.

The Operator Control Panel

If you don't have a computer monitor available and cannot use one
of the user-friendly applications, the alternative is the Operator
Control Panel (OCP) located on the front bezel of the DuraStor
6200SR RAID appliance. It can be used to perform most of the
functions required to monitor your storage devices and create and
manage arrays and spares.
You can find the Operator Control Panel of the DuraStor 6200SR
User's Guide on the DuraStor CD.
For more information, see Appendix B, The Operator Control Panel of
the DuraStor 6200SR.
1-3