Accessing Disk Array Administrator - Adaptec DuraStor 6200SR Installation And User Manual

4 Click OK. The Storage Manager Pro Introduction window
appears.
5 Follow the on-screen instructions to complete the installation.
6 When the installation is complete, click Done.
The Set Administrator Password window appears.
7 Enter a new password, re-enter it to verify it, then click OK. Do
not click OK without changing the password.
Caution: You must change the password immediately. If
!
you do not change the password, you will be unable to log
!
in after the next reboot, and will have to uninstall and
reinstall Storage Manager Pro.
The installation is complete.
You can now perform all of the functions described in the Adaptec
Storage Manager Pro User's Guide.
Warning: We strongly recommend that you regularly and
consistently back up your data so that it may be recovered
in the event of a failure that's not protected by a fault-
tolerant array.

Accessing Disk Array Administrator

Disk Array Administrator is firmware built in to the DuraStor
6200S external RAID controller installed in the DuraStor 6200SR
RAID appliance.
To access Disk Array Administrator, you need
A computer with terminal emulator software, such as
I
HyperTerminal.
A straight-through serial cable. (You cannot use a null modem
I
cable.)
Installing the DuraStor Storage Subsystem
3-25