Table of Contents
Advertisement
DuraStor 6220SS/6200SR/312R Installation and User's Guide
Using the cable, connect the computer to an RS-232 serial port on
the back of your DuraStor 6200SR RAID appliance. Connect to
Serial A port for Controller 1 or Serial B port for Controller 2.
Note: If you are using HyperTerminal as your terminal
emulator software, you must be using HyperTerminal
Private Edition (HTPE) 6.3 for the up and down arrow
↑
↓)
(
or
If you are not using HTPE 6.3, you can download it for free
at www.hilgraeve.com/htpe/index.html.
Configure the RS-232 port in your terminal emulator software
using the settings in
Table 3-2. RS-232 Port Settings
Setting
Terminal Emulation
Font
Translations
Columns
Set the communications parameters for the terminal program as
shown in
Table
Table 3-3. Communications Parameter Settings
Setting
Baud Rate
Data Bits
Stop Bits
Parity
Flow Control
Connector
3-26
keys to work.
Table
3-2.
Value
VT-100 or ANSI (for color support)
Terminal
None
80
3-3.
Value
115,200
8
1
None
Software (XON/XOFF)
COM1 (typically)
Advertisement
Table of Contents
