Start-Up Procedure - Emerson Rosemount CT4400 Reference Manual

Start-up procedure

January 2020
3.3 Start-up procedure
NOTICE
The gases shown in the screenshots and the measurements may be different from those
shown in your particular analyzer. They indicate the functionality of the software, which is
the same regardless of the gases being measured.
CAUTION
To stop the start-up procedure at any time, set the main circuit breaker to OFF.
To start the analyzer, perform the following steps:
Procedure
1. Visually inspect the exterior of the analyzer for signs of damage, corrosion, gas
2. Ensure that the analyzer has been correctly installed.
3. Ensure that the On/Off switch at the rear of the analyzer is set to I (ON).
4. The start-up sequence commences automatically under software control.
5. After a few minutes, the Gas Sensor Main screen
30
leaks, or overheating. Report anything found to the maintenance organization.
See Install.
Figure 3-1: Rear Panel ON/OFF Switch
A. Rear panel
B. On/Off switch
controller. If it does not, report the fault to maintenance.
Reference Manual
00809-0100-4244
(Figure 3-2) appears on the display
Rosemount CT4400