Emerson Rosemount CT4400 Reference Manual page 3

• To prevent electrical shock and personal injury, all equipment doors must be closed and protective covers in place, except
when maintenance is being performed by qualified personnel.
• The information contained in this document is subject to change without notice.
General safety notice residual risk
Installation, operation, and maintenance of the analyzer must be in accordance with these instructions.
When operated as intended and all applicable safety instructions are observed, an element of risk will remain to the emission of
gases hazardous to health when all gas connections have been made correctly.
To avoid exposure to the dangers, care must be taken when installing, operating, maintaining, and servicing the analyzer.
Authorized personnel
NOTICE
In-depth specialist knowledge is an absolute requirement for working with and on the analyzer. Personnel installing, operating,
servicing, and maintaining the analyzer must be instructed, trained and qualified with the operating company and the
manufacturer. It is the operating company's responsibility to:
• Train staff
• Observe safety regulations
• Follow the safety instructions and procedures in the product manual
Operators must:
• Be trained
• Read and understand all relevant sections of the product manual before commencing work
• Know the safety mechanisms and regulations
WARNING
To avoid explosions, loss of life, personal injury, and damage to this equipment and on-site property, do not install, operate,
maintain, or service this analyzer before reading and understanding this instruction manual and receiving appropriate training.
Regulations and standards
Regulations / Standards
2014/35/EU
2014/30/EU
2012/19/EU
USA 21 CFR 1040.1
®
NEC 505
BS EN 61326-1: 2013
EN 61326-1: 2013
IEC/EN 60825-1: 2014
BS EN 61010-1 2010 IEC 61010-1 2010
N/A
Description
The Low Voltage Directive
The Electromagnetic Compatibility Directive
Waste Electrical and Electronic Equipment (WEEE) Directive
Laser products - CFR - Code of Federal Regulations Title 21 part
1040.1
National Electrical Code (issued by ANSI: American National
Standards Institute and NFPA 70: National Fire Protection
Association)
Electrical equipment for measurement, control, and laboratory use
- EMC requirements. General requirements.
Safety of laser products part 1, equipment classification and
requirements.
Safety requirements for electrical equipment for measurements,
control, and laboratory use. General requirements.
Electrical equipment for measurement, control, and laboratory use.
EMC requirements. General requirements.
3