Table of Contents
Advertisement
Write-through
Defaults
Cancel
OK
Saving the Subsystem Configuration
The Storage Manager File menu has the following options:
Read System
Configuration
Set System
Configuration
Load Configuration
File
Save Configuration
File
Note: If you reset the NVRAM on the controller, any changes
to your controller parameters return to the factory defaults.
Writes all data to disk for each Write command
before Command Complete status is returned
to the host. The data can also be cached for
subsequent read commands.
Click to revert to the default setting.
Click to exit this window without saving
changes.
Click to exit with changes.
Reads the current hardware configuration. Any
current changes not saved are lost.
Saves changes that you made to the storage
subsystem configuration. If any arrays have
been created or modified, this action causes the
controller to start build operations for the new
arrays.
Loads a previously saved configuration into
Storage Manager and apply it to the current
hardware.
Saves the current configuration, or any changes
to that configuration, to a file for later use.
Allows storage subsystems to be configured for
other machines with like drives.
Storage Manager
3-34
Advertisement
Table of Contents
