Table of Contents
Advertisement
Controller-Specific
-a
Action (task) control
This switch has the following options which allow you to control
tasks on the controller:
List
Build
Rebuild
Verify
Stop
Specify drives by the device address.
-F
Update controller firmware, BIOS, or NVRAM
This option updates the controller flash memory (EEPROM). Specify
an image file name on the command line.
Note: The -F switch does not work on Novell NetWare
systems. Use SMOR to update the controller flash memory.
For additional information, see
on
ROM.
-X
Reset NVRAM configuration
This option resets the controller NVRAM to the factory default
settings.
-Z
Reset/clear embedded RAID information
This option destroys all RAID information pertaining to disk arrays
and logical drives for the specified device. Specify logical drives by
using the device address.
Shows tasks for the controller
Starts build of logical drive
Starts rebuild on logical drive
Starts a verify operation
Terminates active task on drive
RAIDUTIL Command Line Utility
Chapter 2, Storage Manager
4-8
Advertisement
Table of Contents
