Table of Contents
Advertisement
-I
Display inquiry information
This switch displays controller specific information, including
firmware revision, BIOS version, and serial number. Specify drives
by the device address.
-L
List devices
Specify drives by the device address. The parameters for this switch
are listed below:
Controller
Physical
Logical
Spare
RAID
Array Speed
Redirect
Version
Cache
Inquiry
Battery
All
Note: If a controller is not specified then each controller is
listed, along with all devices on each controller.
Displays a list of all Adaptec controllers in the
system.
Displays all attached devices to the specified
controller.
Displays a list of all logical drives on the controller,
by logical drive number.
Displays a list of all stand-alone hot spare drives.
Displays a list of all configured RAIDs.
Displays a list of the bus speed of all connected
drives.
Displays any redirected devices.
Displays the controller firmware, SMOR, NVRAM,
and BIOS version numbers.
Displays the device caching mode.
Displays the device capabilities as reported to the
controller.
Displays information about the battery backup
module.
Prints out all of the above.
RAIDUTIL Command Line Utility
4-11
Advertisement
Table of Contents
