Table of Contents
Advertisement
The Array Group Information window displays the following
information:
Name
Address
Capacity
Status
Hotspares
Components
Note: The availability of the various buttons depends on the
current configuration and state of the array.
The toolbar at the bottom of the Array Group Information window
contains the following buttons:
Event Log
I/O Stats
Verify
Expand
The descriptive name assigned to the array. An icon
in the upper right corner of the window indicates
the RAID level.
This is the logical device address used by the host
operating system to access the logical drive. The
address is the same as the lowest device address in
the array.
The total usable storage capacity of the array in MB.
The current status of the array as reported by the
controller.
Displays a list of any hot spare drives that are
available to protect the array in the event of a drive
failure.
Displays the logical address, model, and stripe size
for each member of the array. If this is a multilevel
RAID Information window, the list displays the
address or name and stripe size for each disk array
that is a member of the multilevel RAID.
Displays the activity log of the RAID system. For
more information, see
Displays the log of the array's I/O activity. For more
information, see
Starts the process of checking the current status and
operability of the RAID array. For more information,
see
page
3-48.
Windows NT and Windows 2000 only—Allows setting
and checking the parameters of the RAID controller.
For more information, see
page
3-35.
page
3-49.
page
3-21.
Storage Manager
3-15
Advertisement
Table of Contents
