Omron SYSMAC C200HS Installation Manual page 83

Special I/O Units
Analog I/O Units
Temperature Sensor Units
ASCII Unit
The Analog Input (A/D) Units retrieve analog inputs and the Analog Output (D/A)
Unit sends analog outputs.
The following Analog I/O Units are available:
C200H-AD001 with 4-point analog input, C200H-AD002 with 8-point analog in-
put, C200H-DA001 with 2-point analog output, and C200H-DA002 with 4-point
analog output
The Analog Input (AD) Unit is used.
Analog input
Analog output
The Analog Output (DA) Unit is used.
The following table lists Temperature Sensor Unit models and available temper-
ature sensors.
Only one kind of temperature sensor can be connected to the C200H-TS001 or
C200H-TS002. Each Temperature Sensor Unit connects to a maximum of four
temperature sensor inputs.
Model
C200H-TS001
C200H-TS002
C200H-TS101
C200H-TS102
BASIC programs can be input to the ASCII Unit via its port 1 from any personal
computer in terminal mode if the personal computer incorporates an RS-232C
interface.
It is possible to write BASIC programs with an IBM PC/AT or compatible.
Port 1
(RS-232C)
Port 1/2
Preamplifier
transducer
Servomotor controller
variable adjuster
Connectable temperature sensor
K (CA)/K (IC)
K (CA)/L (Fe-CuNi) (available for DIN)
JPt 100 Ω
Pt 100 Ω (available for DIN/1989JIS)
Thermocouple: K (CA), J (IC), L (Fe-CuNi)
Platinum resistance thermometer: JPt100 Ω, Pt100 Ω
BASIC Program:
Personal computer
Input: Bar code reader
Output: Printer and plasma display
Section 5-4
Sensor
Motor
69