Omron SYSMAC C200HS Installation Manual page 188

Specifications
Pin 3: Minimum Pulse Width Setting of Pulse Input Response
Use pin 3 only when pin 2 of the C200H-ID501, C200H-ID215, C200H-MD501, C200H-MD115, and C200H-
MD215 is set to ON (i.e., when pulse input is set).
Pin 4: Input Response Time Setting
Use pin 4 for the C200H-ID501, C200H-ID215, C200H-MD501, C200H-MD115, and C200H-MD215 only.
Pin 5: Dynamic Data Output Logic Setting
Use pin 5 only when the C200H-OD501 or C200H-OD215 is in dynamic output mode (i.e., when pin 1 is set to ON).
DIP Switch Settings for High-density I/O Unit (Special I/O Unit)
Model
C200H-ID501/215
C200H-OD501/215
C200H-MD501/115/215
174
Pin 3
OFF 1 ms
ON 4 ms
Pin 4
OFF 2.5 ms max.
ON 15 ms max.
Pin 5
OFF Negative logic output
ON Positive logic output
Pin 1 Pin 2
Setting is Must be set
not required
OFF Setting is
not required
ON Setting is
not required
OFF Must be set
ON Setting is
not required
Minimum response input pulse width
Input response time
Data output
Pin 3 Pin 4
Set when Must be set
pulse input
is used
Setting is Setting is
not required not required
Setting is Setting is
not required not required
Set when Must be set
pulse input
is used
Setting is Setting is
not required not required
Appendix B
Pin 5 Pin 6
Setting is Setting is
not required not required
Setting is Setting is
not required not required
Must be set Setting is
not required
Setting is Setting is
not required not required
Setting is Setting is
not required not required