Procedures In The Event Of Hazards And Accidents; Maintenance And Cleaning Of The Freeze-Dryer - Christ Beta 1-8 LSCbasic Operating Manual

Freeze-dryer Beta 1-8 LSCbasic
Freeze-dryer Beta 2-8 LSCbasic
3 Safety
→
3.9

Procedures in the event of hazards and accidents

3.10

Maintenance and cleaning of the freeze-dryer

30 / 107
Hazardous electrical incident:
•
Set the control switch to the "0" position in order to interrupt the power
supply completely.
Fire:
•
A fire in the electrical control system must be extinguished with a CO
fire extinguisher!
•
Burning oil must be extinguished with a CO
fire extinguisher!
Electric shock:
•
While ensuring your own safety, interrupt the circuit as quickly as
possible (control switch). Keep the affected persons warm and calm.
Get medical attention immediately! Check consciousness and
breathing continuously. In the case of unconsciousness of lack of
normal breathing, perform cardiopulmonary resuscitation (CPR).
Burns:
•
Cool small-area burns (e.g. finger) immediately with cold water for
approximately 2 minutes.
•
Do not cool if larger areas of the body surface are burnt since there is a
risk of hypothermia.
•
Cover the burns loosely and in a sterile manner (e.g. with sterile
dressing).
•
Keep the affected persons warm and calm.
IF IN DOUBT, CALL THE EMERGENCY PHYSICIAN (AMBULANCE)!
The substances and materials that are used must be properly handled and
disposed of (Please refer to the safety data sheets!). This applies
particularly to
•
the handling of solvents, lyes, and acids,
•
the changing and topping-up of operating supplies.
Compliance with the national rules and regulations must be ensured.
fire extinguisher or powder
2
Version 03/2018, Rev. 1.5 of 09/03/2020 • sb-dc
Translation of the original operating manual
2