Figure 6 Fr/Rl Bracket Orientation - Silicon Graphics 1450 Mounting Instructions

007-4242-001
C
Figure 6 FR/RL Bracket Orientation
A. Rear Left Bracket
B. Lower Tongue
C. Extended Slide
Assembly
4. Align the slot in the bracket with the three holes in the outer member so that all
three holes in the outer member are visible through the slot in the bracket.
5. Place screws in the two front holes from inside the outer member and loosely
tighten with a washer and lock nut. The correct alignment of the screw, washer, lock
nut, bracket, and slide assembly is shown in Figure 7.
A
The front left bracket is labeled FR/RL.
The correct orientation of the lower tongue of the bracket
safety latch is shown.
The intermediate member is extended so that the three screw
holes on the outer member are accessible.
Attaching EIA Rail Brackets
B
11