Clear Accumulator; Enter New Unit Id; View And Edit Time Value - Rice Lake Synergy 680HE Technical Manual

3.4.14 Clear Accumulator

1. Press . audit displays.
2. Press or
3. Press . dspacm displays.
4. Press . clracm displays.
5. Press or
6. Press or
7. Press to return to weigh mode.

3.4.15 Enter New Unit ID

Entering a new Unit ID requires access to setup mode
1. Press . audit displays.
2. Press . setup displays.
3. Press . config displays.
4. Press to scroll until progrm displays.
5. Press . pwrupm displays.
6. Press to scroll until uid displays.
7. Press . The current unit ID value displays.
8. Edit the value using the keypad
9. Press when the value is correct.
10. Press to return to weigh mode.

3.4.16 View and Edit Time Value

To view and edit the current time:
1. Press . audit displays.
2. Press multiple times until time displays.
3. Press to view the current set time.
4. To edit the time value use the following method:
• Press to clear the current time
• Use the numeric keypad to enter the new time value
• Press to accept the new time value once correct
5. Press to return to weigh mode.
Time is backed up by the internal battery and is not lost if the main power is interrupted.
Note
See Section 4.4.5 on page 30
until accum displays.
to clear the accumulator value. ok displays.
to return the accumulator menu parameters.
(Section 4.1 on page
(Section 3.3.1 on page
for time formatting options.
© Rice Lake Weighing Systems ● All Rights Reserved
21).
15).
Operation
19