Table of Contents
Advertisement
Maxi Lift 87.6" wingspan, 33cc
8) Move the throttle stick to the closed posi-
tion and move the carburetor to closed. Use
a 2.5mm hex wrench to tighten the screw
that secures the throttle pushrod wire. Make
sure to use threadlock on the screw so it does
not vibrate loose.
12
Instruction Manual.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
1 PCS
INSTALLING THE STOPPER
ASSEMBLY.
1) Using a modeling knife, carefully cut of
the rear portion of one of the 3 nylon tubes
leaving 1/2" protruding from the rear of the
stopper. his will be the fuel pick up tube.
2) Using a modeling knife, cut one length of
silicon fuel line. Connect one end of the line
to the weighted fuel pick up and the other
end to the nylon pick up tube.
Adjustable Servo
connector.
Servo arm.
Advertisement
Table of Contents
