Newer Series 700 And Series 800 (K/D Class) - HP 9000 Manual

To Search for Servers: 1. Type the following:
2. If your Ignite-UX server does not appear during the search, type "x"
3. If you know the Ethernet™ address of your server and can specify
• If your server is listed during the search, then you can boot the
• Alternatively, you can exit this screen by typing "x

Newer Series 700 and Series 800 (K/D Class)

After the power is turned on, you will see a graphical interface screen
(Series 700) that displays instructions to press
process. (On Series 800, the interface will be TUI.)
1. Press
Figure 5-3
Chapter 5
Enter
search lan
in order to exit.
• If necessary, type the search command again:
search lan
Note that it will typically take two or three searches before the
Ignite-UX server will be found, due to a built-in delayed response
from the server system.
• Identify your LAN server from the listing.
• If three attempts result in no response from the desired server, see
Chapter 6, "Troubleshooting."
where to boot without going through the search process, type:
boot lan.080009-nnnnnn
where 080009-nnnnnn is the Ethernet address of the install server.
(Some newer systems may not use the 080009 prefix.) This number
can be found by running the lanscan(1M) command on the server.
system by typing "p" and the index number of the server. For
example:
p1
This will cause the boot to begin. OR
"boot p1" at the previous screen.
, and you should see the following menu:
ESC
Installing from the Ignite-UX Server
Network Source Installation
", and typing
Enter
to stop the boot
ESC
83