HP 9000 Manual page 72

Configuring an Ignite-UX Server
Setting Up an Ignite-UX Server
Figure 4-2
The Server Options • Select on Default Configurations, highlight the one you want to use
Tab
• Click on the selection list to display the available (configured)
• Select the appropriate Client Timeout time, or "Off", to set the time
72
from the list. When doing a client installation, this configuration will
be installed on targets if no other is specified. (The default setting can
be overridden on a per-client basis by Ignite-UX).
printers. Select the one you want to use.
If necessary, use the SAM → Printers and Plotters area to configure a
new printer onto the system.
This will be the printer for printing the manifest or installation
history. The printer address will be checked by Ignite-UX before a job
is sent.
limit for the client to be connected without responding. (This will set a
limit on the time since the client install log has been written in.
Fifteen to thirty minutes may be required at some points in the
installation.) A warning note will be displayed if this time is
exceeded.
Setting Client Timeout to "off" disables this notification.
Chapter 4