HP 9000 Manual page 110

Installing from the Ignite-UX Server
Configuring the Installation
Fixed size:
All Remaining:
Free Size:
Free Percent:
Size Range:
Add/Remove Disks This opens a display which allows you to do the following:
• Add a new disk and configure its file system type and volume group
• Remove a disk from current usage on the target system by
• Determine your current disk usage.
To change a disk usage status:
• Select a disk in the display list.
• Select the "Usage" selection list to set a new usage. If you select
• Select the "Vol Grp:" button to see the Volume Group Choices or type
• Select the Modify button, to execute any changes.
110
The selected (highlighted) file system is set to this size.
The selected file system automatically takes over all
remaining file system space on the disk or volume
group.
Use this selection when you know how much free space
you wish the volume to have after the system is
installed. The size of the volume will be the specified
amount plus the amount the selected software
requires.
This category is similar to free size, but expressed in
percent. It is used if you know how full you wish the
volume to be, in percentage of the volume size. If you
indicate "20%", then the volume would be 80% full after
the installation of the selected software.
Select this category in the list to set a maximum size
for the file system (the minimum is determined by the
software impact on the volume).
designation, if any.
designating it as "Unused".
"LVM", a Vol Grp:... button appears.
in a new volume group name in the entry field.
Chapter 5