HP 9000 Manual page 106

Installing from the Ignite-UX Server
Configuring the Installation
Figure 5-17
This screen enables you to configure different network interface card(s).
You can enter or change IP and Subnet information, as needed, and
designate the Primary Interface.
NOTE If the target system has more than one interface, the LAN card
designated as Primary will be the one that is associated with the host
name of the system in /etc/hosts.
• Select an interface card from the selection list.
• Enter or modify the IP Address, as needed.
• Enter or modify the Subnet Mask, as needed.
• Activate Primary Interface, depending on the status you want for this
• Select Modify when you have finished with changes for each interface.
106
interface.
Chapter 5