HP 9000 Manual page 27

Specify Source Screen
Figure 2-2
1. Clicking on the field beside Source Depot Type displays a choice of
2. If the source depot/host name filled in is not the one you want, enter
3. If you click on Source Depot Path, you will get a listing of available
4. If you wish to limit the listing, click on Software Filter to see the list
5. Click on OK.
For More Information For information on the options for swinstall, and to change the degree
of detail for its logging functions, see the manual Managing HP-UX
Software with SD-UX.
Chapter 2
Local CDROM, Local Directory, Local Tape, or Network
Directory/CDROM. The latter category will get a remote source for
the update.
the correct one. You may also use the IP address for a host.
depots on the source you have just specified. If the source is a tape
device, you may need to type the device file name. The mount point
for a CD-ROM should already exist as /SD_CDROM, if the system was
cold-installed. For more detail, see the man page swreg(1m).
of filters protocols available. At the same time, you can select one or
none.
You will next see the Software Selection screen.
Updating an Existing Operating System and Software
Updating HP-UX Software
27