After Selecting Boot Paths (Series 700 And 800) - HP 9000 Manual

5. To the question "Interact with IPL (y or n)?", respond with
After Selecting Boot Paths (Series 700 and
800)
1. If you see the following question on your screen, type n:
2. You can abort the installation at this point, if you wish, by turning
3. When you have chosen the boot path and loaded the Ignite-UX utility,
Time Note Loading the Install Kernel should take 3 to 5 minutes.
After booting from media, you will first see the following screen on
Choosing a Language
for Interaction
systems that have a PS2 keyboard:
Chapter 3
• If neither the primary or alternate device paths correspond to that
for the tape or CD-ROM device, then respond with "n" to both
prompts. In this case, enter the hardware path of the device (for
example, 52.3.0) at the prompt "Enter boot path, command,
or ?>".
"n".
Interact with IPL (Y or N)?> n
the system off and starting over.
the system will display the Ignite-UX keyboard languages screen, if
your target system has a PC-style keyboard. From this point on, you
can respond to the requests for information on this and the following
screens.
Installing From Media
Booting the Target System
47