Setting Up An Ignite-Ux Server - HP 9000 Manual

Setting Up an Ignite-UX Server

Ignite-UX functions through a client-server system. Much of the server
setup process will be performed for you in the Ignite-UX installation
process, but there are also some separate steps you must take after
installation. Tools are supplied to help you complete the server setup.
The following steps outline setting up or updating the server:
1. Obtain access to a suitable system running HP-UX 10.x. For
information on upgrading from a 9.x system to 10.x, please see the
manual Upgrading from HP-UX 9.x to 10.x.
2. If required, update with Extension Media from CD-ROM (see Chapter
2, "Updating an Existing Operating System and Software.")
3. Install the Ignite-UX tools and data from the HP-UX Applications
tape or CD-ROM, using the swinstall utility.
If you are updating a new pre-10.30 system, this may require running
swgettools first to update swinstall. (See Chapter 2, "Updating
an Existing Operating System and Software.")
The current bundle names are:
• B5724AA_UM3 (for I-UX S700).
• B5725AA_UM3 (for I-UX S800).
Versions that are on the DART Applications media will be labeled
B5724AA.APZ or B5725AA.APZ.
4. The release-specific bundles within these each contain the filesets
needed for installing a particular release to your clients.It is
recommended that you load one or more of these release-specific
bundles. They are designated as follows:
Ignite-UX-10-01
Ignite-UX-10-10
Ignite-UX-10-20
. . .
You may load one or more of the Ignite-UX-10-XX bundles onto your
server depending on which releases of HP-UX you plan on installing onto
clients. That is, you can choose to load a release-specific bundle, such as
Ignite-UX-10-20, or the entire bundle, such as B5724AA_UM3,which
would give you all the release-specific bundles..
Chapter 4
Configuring an Ignite-UX Server
Setting Up an Ignite-UX Server
67