HP 9000 Manual page 73

• Use the Interface selection list to designate where you want to see the
NOTE The default location for the interface display is the Ignite-UX server, if
the server is running.
• To use Add Booting IP Addresses..., see the following section.
Adding Booting IP If you clicked on Add Booting IP Addresses..., in Figure 4-2, you would
Addresses...
get the following screen.
Figure 4-3
Booting Clients This screen allows you to enter appropriate values to use for IP
addresses for the initial boot of the target systems. The number of such
addresses determines the number of simultaneous installations you can
do.
First, ensure that these IP addresses are not assigned elsewhere. These
IP addresses are used to initially boot the target systems. They are used
until the system is assigned one of the DHCP-assigned boot addresses.
One address is required for each simultaneous boot. Typically one to
three are needed, depending on your usage.
Chapter 4
client UI for this installation. If you have a server configured, you can
have the choice of running the client installation interface from either
the target (as a Terminal User Interface) or the Ignite-UX server (as a
Graphical User Interface). If the client installation is to be
non-interactive (no interface), select "None".
Configuring an Ignite-UX Server
Setting Up an Ignite-UX Server
73