Bsc Programming Example - Cypress WICED CYW920706WCDEVAL Hardware User's Manual

*/
uint8_t test_spiffy1_slave_send_receive_byte( void )
{
uint8_t byteReceived;
/* Rx one byte of data */
wiced_hal_pspi_rx_data( 1, &byteReceived );
/* Send back byteReceived + 1 */
byteReceived++;
/* Tx one byte of data */
wiced_hal_pspi_tx_data( 1, &byteReceived );
}

10.4 BSC Programming Example

The following example shows how to initialize the BSC as a master, and how to write, read, and use the combination write-
then-read transactions.
#include "wiced_hal_i2c.h"
#define I2C_SLAVE_ADDRESS
#define I2C_SLAVE_OPERATION_READ
#define I2C_SLAVE_OPERATION_WRITE
/* Sample code to test i2c driver */
void test_i2c_driver( void )
{
uint8_t data_array[] = "123456";
/* Initializes the I2C driver and its private values. This initialization
* sets the bus speed to 100KHz by default (I2CM_SPEED_100KHZ)*/
wiced_hal_i2c_init( );
/* current I2C bus speed */
wiced_hal_i2c_get_speed( );
/* Sets the I2C bus speed
*(I2CM_SPEED_100KHZ/ I2CM_SPEED_400KHZ/ I2CM_SPEED_800KHZ/ I2CM_SPEED_1000KHZ)*/
wiced_hal_i2c_set_speed( I2CM_SPEED_400KHZ );
/* Writes the given data to the I2C HW addressing a particular slave address */
wiced_hal_i2c_write( data_array, sizeof( data_array ), I2C_SLAVE_ADDRESS);
/* Reads data into given buffer from the I2C HW addressing
* a particular slave address */
wiced_hal_i2c_read( data_array, sizeof( data_array ), I2C_SLAVE_ADDRESS);
WICED_BT_TRACE( "Read bytes %s\n\r", data_array );
}
CYW920706WCDEVAL Hardware User Guide
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Interface Programming Information and Examples
(0x1A) /* Use driver slave address 0x1A =
* (7'b0001101 << 1) | 1'bR|W */
0 /* Read operation to the lower level
* driver is 0 */
1 /* Write operation to the lower
* level driver is 1 */
Doc. No.: 002-16535 Rev. ** 40