REA JET HR pro 2K User Manual page 87

View / Functional element
1
c
b
a
Instruction manual
REA JET HR pro 2K / 4K
V 3.5x_001 28.05.2015
Spring preload
The slidable sleeve on the rod is at its lower end equipped
with the "upper" mount for the springs. The preload of the
springs is determined by the position of the sleeve 2. This
sleeve can snap into place along the rod 1 in 10 different
positions. In the position close to the swinging link, the
preload is lowest, and the position farthest away from the
2
swinging link is the highest.
Functional direction
Print from top:
When printing from the top, relief of the swinging link is
achieved by suspending the springs in the position point a, b
or c. The farther away the position point is from the rod, the
higher the relief.
a:
b:
c:
Print from the side:
With this operating mode, the print head has to be led
(pressed) to the product. For this purpose, the springs have
be be suspended in the position point d.
d
The locating pins of the springs have an M4 thread and can
be easily mounted to the desired position with a 7 mm fork
wrench and a slotted screwdriver
Figure 96: Setting options of the parallelogram
Figure 97: Arrangement / assembly for printing from the side
Page 87 / 189
Description
highest relief
medium relief
lowest relief
Copyright © REA Elektronik