Table of Contents
Advertisement
42
C
2: I
HAPTER
NSTALLING THE
W
EBCACHE
b Tighten the retaining screws on the cable to prevent it from being
loosened.
c Connect the other end of the cable to your terminal, terminal
emulator, or modem. Make sure that the terminal, terminal emulator,
or modem have the same settings as the console port:
8 data bits
I
no parity
I
1 stop bit
I
2 To configure the settings of the terminal, terminal emulator, or modem,
see the documentation that accompanies it. You must configure the
terminal and set the line speed (baud) to 9600. You can change the baud
rate of the console port via the Web interface.
Accessing the Command Line Interface
To access the Command Line Interface, take the following steps:
1 The login sequence for the Command Line Interface begins as soon as
the Webcache detects a connection to its console port, or as soon as a
Telnet session is started.
If the login sequence does not begin immediately, press Return a few
times until it does begin. If the sequence still does not begin, see "Solving
Command Line Interface Problems" on page 133.
2 At the Login and Password prompts, enter your user name and password.
For further information, see "Logging in as a Default User" on page 58.
3 If you have logged on correctly, the Top-level menu of the Command Line
Interface is displayed as described in "Understanding the Command Line
Interface" on page 112. If you have not logged on correctly, the message
Incorrect password.
4 Access the Getting Started wizard, which allows you to quickly configure
the basic setup information for the Webcache.
At the Top-level menu, enter:
gettingStarted
5 The Getting Started wizard is displayed. You must configure the basic
settings of the Webcache by completing the Getting Started wizard
before you introduce the Webcache to your live network. For more
information, see "Getting Started Wizard Settings" below.
is displayed and the login sequence starts again.
Advertisement
Table of Contents
