Table of Contents
Advertisement
Rebooting the
Webcache
Specifying a Contact
Name
Displaying and Changing Webcache Information and Functions
2 Enter
if you wish to proceed, or
yes
initialization.
What Happens During an Initialization?
Initializing the Webcache returns it to its default (factory) settings; for
more information see "Default Settings" on page 22.
You may want to initialize the Webcache if it has previously been used in
a different part of your network, and its settings are incorrect for the new
environment.
CAUTION: Use great care when initializing the Webcache. It removes all
configuration information, including password and security information.
The Webcache takes approximately 60-90 seconds to initialize. While the
Webcache is initializing, you cannot communicate with it.
You can reboot the Webcache using the
Control menu.
To reboot the Webcache:
1 At the Top-level menu, enter:
system control reboot
The following prompt is displayed:
Are you sure you want to reboot the system (yes,no) [no]:
2 Enter
if you wish to proceed, or
yes
What Happens During a Reboot?
Rebooting the Webcache simulates a power-off/on cycle. The Telnet
session to the Webcache will be terminated.
The Webcache takes about approximately 60-90 seconds to reboot.
While the Webcache is being rebooted, you cannot communicate with it.
You can specify contact name details for the Webcache using the
command on the Management menu.
contact
if you want to stop the
no
command on the
reboot
if you want to stop the reboot.
no
123
Advertisement
Table of Contents
