Enabling And Disabling Password Recovery; Displaying And Changing Webcache Information And Functions; Initializing The Webcache - 3Com SuperStack 3C16115 User Manual

122 C 12: C
HAPTER OMMAND
Enabling and
Disabling Password
Recovery
Displaying and
Changing
Webcache
Information and
Functions
Initializing the
Webcache
L I
INE NTERFACE
You can enable or disable password recovery for the Webcache using the
command on the Security menu. For more information
pwdRecover
about password recovery, see the "Security"chapter on page 71.
CAUTION: 3Com recommends that you leave Password Recovery
enabled. If you disable it and subsequently forget the password for the
admin user name, you will have to return the Webcache to 3Com.
To enable or disable password recovery:
1 At the Top-level menu, enter:
security pwdRecover
The following example prompt is displayed:
The Password Recovery feature is enabled.
Enter new value (enable,disable) [enable]:
You can display and change information about the Webcache using the
commands on the System menu. These commands allow you to:
Initialize the Webcache to factory default settings
I
Reboot the Webcache
I
Specify a contact name for the Webcache
I
Specify location details for the Webcache
I
Specify a name for the Webcache
I
Specify a community string for the Webcache
I
Display summary information for the Webcache
I
You can initialize the Webcache using the
Control menu.
To initialize the Webcache:
1 At the Top-level menu, enter:
system control initialize
The following prompt is displayed:
WARNING: This command initializes the system to factory
defaults (excluding IP details) and causes a reset.
Do you wish to continue (yes,no) [no]:
command on the
initialize