Loading Paper Into Tray 2 - Ricoh Pro C7100s Operating Instructions Manual

Loading Paper into Tray 2

• Check the paper edges are aligned at the right side.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• When loading a low number of sheets, be sure not to squeeze the side fences in too tightly. If the
side fences are squeezed too tightly against the paper, the edges may crease, the paper may
misfeed, or if it weighs between 52.3–63.0g/m
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Square the paper and load it print side down.
Do not stack paper over the limit mark.
3. Carefully push the paper tray fully in.
• Various sizes of paper can be loaded in Tray 2 by adjusting the positions of side fences and end
fence. For details, see page 138 "Changing the Paper Size in Tray 2".
2
(14.0–16.9 lb. Bond), it may wrinkle.
DER060
DER061
Loading Paper
125