Ricoh Pro C7100s Operating Instructions Manual page 152

4. Paper Specifications and Adding Paper
9. Carefully slide the paper tray fully in.
• After sliding the paper tray in, make sure that the paper size is changed correctly on the printer's
initial screen. To display the printer's initial screen, display the [Home] screen and press the [Printer]
icon.
• You can load envelopes into the two-tray wide LCT. When loading envelopes, place them in the
correct orientation. For details, see page 177 "Envelopes".
• When you load paper that is 420.0 mm (16.54 inches) or wider in the banner sheet tray of the
two-tray wide LCT, load it as follows:
• Press the elevator switch to move the bottom plate down until the lamp goes out, and then
open the cover and load the paper.
• Hold the paper lengthwise and load it little by little.
• If you load thin paper or coated paper, load it little by little. Press down on the paper while
you load it so that the paper loaded in the bottom is not dragged.
• If you load thick paper, load it little by little and align the side fence with the horizontal side of
the paper.
• Check that the paper is correctly positioned against the back of the paper feed tray and the
label on which is printed the paper sizes for the paper tray.
• When you load paper that is 420.0-559.9 mm (16.54–22.00 inches) wide, use two short-
end fences. When you load paper that is 560.0-700.0 mm (22.00–27.55 inches) wide, use
one long-end fence.
• When you load paper that is thicker than Paper Weight 5, load the paper and set the
auxiliary side fence. Align the auxiliary side fence against the side of the paper that is higher
than the side fence extension.
Attaching the tab fence in the two-tray wide Large Capacity Tray
When loading tab stock, attach the tab fence.
150
DER096