Ricoh Pro C7100s Operating Instructions Manual page 36

2. Getting Started
• You cannot install the three-tray wide LCT and the two-tray wide LCT simultaneously.
• If you have connected two high capacity stackers, you cannot install the multi-folding unit, the ring
binder, or the perfect binder.
• You can install the multi-folding unit only if either Finisher SR5050 or Booklet Finisher SR5060 is
installed.
• You can install the ring binder or the perfect binder only if one of the following options is installed:
Finisher SR5050, Booklet Finisher SR5060, or the high capacity stacker.
• You can install the trimmer only if Booklet Finisher SR5060 is installed.
• You can install the high capacity stacker only if the decurl unit is installed.
• You cannot install the ring binder and perfect binder simultaneously.
• The multi bypass tray (Tray A) can be attached only if either the three-tray wide LCT or the two-tray
wide LCT is installed. However, you can attach the multi bypass tray (Tray A) to the two-tray wide
LCT only if the multi bypass attachment kit is installed.
Removing prints from finisher during printing
This section describes how to suspend a large copy or print job when using the finisher.
Depending on the image you are copying or printing, prints might not stack properly. If this happens,
suspend the job, remove the prints and then restart the job.
1. Press the [Suspend / Resume] key.
1. [Suspend / Resume] key
34
1 1
DER120