Ricoh Pro C7100s Operating Instructions Manual page 151

1
1. Supporting plates
6. Take the grip of the side fences with your fingers, and adjust the side fences to the paper
size.
Set the paper flush against the protrusions in the bottom of the inner side fence.
Check that the scale numbers on the top of the side fences are roughly the same.
7. Load additional sheets, if necessary.
Do not stack paper over the limit mark.
8. Tightly fit the end fence to the loaded paper, and then re-lock the end fence again.
Make sure there are no gaps between the paper and end fence.
DER094
DER093
DER095
Changing the Paper Size
149