LAN Problems with NDIS2 Drivers
Symptom
No adapter detected.
Card services could not allocate
LAN IRQ.
Card services could not allocate
LAN I/O PORT base address.
Bank select port failed to
respond.
Enabler cannot activate the card.
Enabler activates the card but it
cannot see the server.
Enabler fails to find the card
LAN Problems with NDIS2 Drivers
Solution
LAN+Modem is not in the PCMCIA slot, or is
not being recognized by C&SS.
The value specified for Interrupt in the
PROTOCOL.INI file is not available. Try using
another address.
Use File/Edit Configuration to check that the
LAN IRQ does not conflict with any IRQs
already in use. If so, change the IRQ setting
(make the same change in PROTOCOL.INI).
The I/O base-address value in the
PROTOCOL.INI file is not available for use. Try
another port address. Check that the base
address setting in Card and Socket Services
matches that in PROTOCOL.INI.
Try to make more resources available (BIOS).
Try to force Enabler to use a different IRQ
(possibly found by CONFIG), for example:
FMENABLE IRQ=A
Where A is the hexadecimal value of 10.
Verify the EMM386.EXE settings in
CONFIG.SYS.
57
Need help?
Do you have a question about the 3CCFEM556 and is the answer not in the manual?