Running Setup To Install Microsoft Network Clients - 3Com 3CCFEM556 User Manual

24 C
HAPTER

Running Setup to Install Microsoft Network Clients

During the Setup procedure, you will be prompted to insert
the LAN+Modem card into any PC Card slot in your
notebook. If you need directions for inserting the card,
refer to Chapter 2, "Inserting and Connecting the Card,"
in this Guide.
To install your LAN+Modem card under Windows:
1 Insert Installation Disk 1 into your computer's floppy
drive.
2 Click File from Program Manager.
3 Click Run.
4 Enter a:\setup
5 Follow the prompts as they appear. If you have
questions about what appears on a screen, click Help
and read the explanation that appears.
Setup prompts for a directory for installing the LAN+Modem
card software. The default directory is C:\MHZ. If you specify
a different directory, note the new name. You will need to
supply it later.
6 When the Network window appears during Setup,
select the network driver that will give you access to
your network.
What driver you select depends on the kind of network
you're running. Most users will load an ODI driver for
Novell NetWare networks or an NDIS driver for Microsoft
networks. Change the Primary Network Log on to your
network type if you need to. Click OK.
7 Remove the Installation Disk and click Yes to restart
your computer.
Before using the modem, make sure the communications
software you plan to use is installed and that the cables are
connected as described in Chapter 2.
Before you can use the network connection, you must
install the network driver as described in the following
sections. See your system administrator or network
manuals for installation procedures.
5: I
NSTALLATION FOR
W W
INDOWS FOR ORKGROUPS