3Com 3CCFEM556 User Manual page 21

Do not insert the LAN+Modem card until you're instructed
to do so.
1 Insert Installation Disk 1 into your computer's floppy
drive.
2 Click Start.
3 Click Run.
4 Enter a:\setup
Follow the instructions as they appear on the screen. Setup
prompts for a directory for installing the LAN+Modem card
software. The default directory is C:\MHZ. If you specify a
different directory, note the new name. You will need to
supply it later during the Setup process.
5 When prompted, insert the LAN+Modem card into
any available PC Card slot as described in Chapter 2.
Allow Windows 95 to detect and configure your card and
its components.
6 Provide modem information if prompted: country,
area code, and number to access an outside line.
7 Provide computer and workgroup names for your
LAN setup if prompted.
8 After your network configuration is displayed, make
sure that you have all necessary clients, protocols and
services installed. Click OK and say "No" when asked
to reboot
9 After the "Congratulations!" screen is displayed, reboot.
Before using the modem, make sure the communications
software you plan to use is installed and that the cables are
connected as described in Chapter 2.
Before you can use the network connection, you must
properly configure the network settings (open the
Control Panel and double-click Network). See your system
administrator or network manuals for installation procedures.
Running Setup 15