Installing The Fax Option - Ricoh Aficio 1013 Service Manual

1.2.2 INSTALLING THE FAX OPTION

!
CAUTION
1. Before starting installation, be sure to save the SRAM data (user
settings) from the existing FCU into an external memory card. After
completing the installation, load the save data into the new FCU.
2. If there is a printer option installed in the machine, proceed as follows.
1) Print out all print data from the printer buffer.
2) Remove the printer option from the machine.
3) Install the fax option.
4) Reinstall the printer option.
1. Turn the power off, and then insert a
memory card [A] into the card slot [B].
2. Turn the power on, and run SP5-824 to save
(upload) the SRAM data from the current FCU into the memory card. (For
instructions, see Section 5.1.8 of the base copier's service manual.)
3. Turn off the main switch, remove the memory card, and disconnect the power
cord.
4. Remove the platen cover [C]. To
remove: Lift the cover, unlatch
the two latches [D] (press down
on the tabs [E] and push the
latch back), and detach the cover
from the hook [F].
SM
[B]
[E]
1-3
FAX UNIT
[A]
B465I500.WMF
[C]
[D]
[F]
B465I501.WMF
B465