Ricoh Aficio 1013 Service Manual page 290

BIT SWITCHES
Plotter Switch 03
No. FUNCTION
4–7 Page separation threshold (with reduction disabled with switch 03-0 above)
If the incoming page is up to x mm longer than the length of copy paper, the excess
portion will not be printed. If the incoming page is more than x mm longer than the
length of copy paper, the excess portion will be printed on the next page.
The value of x is determined by these four bits.
Hex value of bits 4 to 7
and so on until
Default setting: 6 mm
Cross reference
Length reduction On/Off: Plotter Switch 03, Bit 0
Plotter Switch 04 and 05
No. FUNCTION
0–7 Reduction ratios used for different paper sizes (with reduction enabled in switch 03-
bit 0 above)
If reduction is enabled, the data will be reduced in the lengthwise direction before
printing.
These switches determine the maximum reduction ratio for each paper size.
Cross-reference
Switch 04/05
Bit0
Bit1
Bit2
Bit3
Bit4
Bit5
Bit6
Bit7
SW04 SW05
0
1
0
1
Plotter Switch 06 - Not used (do not change any of these settings)
Plotter Switch 07 - Not used (do not change any of these settings)
Plotter Switch 08 - Not used (do not change any of these settings)
Plotter Switch 09 - Not used (do not change any of these settings)
Plotter Switch 0A - Not used (do not change any of these settings)
Plotter Switch 0B - Not used (do not change any of these settings)
Plotter Switch 0C - Not used (do not change any of these settings)
B465
x (mm)
0 0
1 1
F 15
Paper used
A5 sideways/HLT sideways
Not used
LT/B5
A4
F
LG
Not used
Not used
Reduction Ratio
0 Disabled
0 4/3
1 8/7
0 12/11
5-18
COMMENTS
COMMENTS
SM