Ricoh Aficio 1013 Service Manual page 281

System Switch 01
No. FUNCTION
0 PM call
0: Disabled 1: Enabled
1 Auto service call
0: Disabled 1: Enabled
2–7 Not used
System Switch 02
No. FUNCTION
0 Memory file transfer
0: Disabled 1: Enabled
1–3 Not used
4 Automatic reset (during
communication)
0: Disabled 1: Enabled
5 Not used
6, 7 Memory read/write by RDS
Bit 7 6 Setting
0 0 Always disabled
0 1 User selectable
1 0 User selectable
1 1 Always enabled
SM
COMMENTS
This bit switch determines whether the
machine will send an Auto Service Call to the
service station when it is time for PM.
This bit switch determines whether the
machine will send an Auto Service Call to the
service station when a fatal error occurs.
This bit is changed to 0 (disabled)
automatically when the machine called a not
fax machine or a wrong fax machine.
Cross-reference
Communication Switch 02 bits 4 and 5 -
Wrong connection prevention method (Service
station)
Do not change these settings.
COMMENTS
1: All messages in the memory (including
confidential RX messages) are sent to the
fax number that is stored as the service
station.
Always reset this bit to zero after transfer.
Cross-reference
Service station number: Function 09
Do not change these settings.
1: The machine automatically returns to
standby mode when a page takes more
than a certain time to send (the default
setting is 60 minutes).
This timer can be adjusted with RAM
addresses 4004C0 and 4004C1.
Cross-reference
Service RAM Addresses, section 5.5.
Do not change the setting.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are
locked out, but the user can temporarily switch
RDS on to allow RDS operations to take
place. RDS will automatically be locked out
again after a certain time, which is stored in
System Switch 03 (see below). Note that if an
RDS operation takes place, RDS will not
switch off until this time limit has expired.
(1,1): At any time, an RDS system can access
the machine.
5-9
BIT SWITCHES
B465